How to Install a Bidet Attachment in 10 Minutes — No Plumber, No Electricity Needed

Think Installing a Bidet Attachment Is Complicated? Think Again.

The EcoAqua Pro S5 is designed for easy DIY installation — no plumber, no electrician, and no special tools required. Follow this step-by-step guide and you'll be enjoying a cleaner bathroom experience in under 10 minutes.

What You'll Need

• Your EcoAqua Pro S5 bidet attachment (everything included in the box)
• A towel or small bucket (to catch any drips)

Step-by-Step Installation

1. Turn off the water supply. Locate the shut-off valve behind your toilet and turn it clockwise until closed.
2. Flush to empty the tank. This relieves pressure in the supply line.
3. Disconnect the supply hose. Unscrew the hose from the bottom of the toilet tank. Have your towel ready for drips.
4. Install the T-valve. Connect the included T-valve between the shut-off valve and the supply hose. Hand-tighten, then snug with a wrench — do not overtighten.
5. Connect the bidet hose. Attach the S5's braided hose to the T-valve outlet. Hand-tighten.
6. Remove the toilet seat. Unscrew the two bolts at the back of the seat.
7. Position the S5. Slide the bidet attachment onto the toilet bowl mounting holes, aligning with the seat bolt holes.
8. Reinstall the toilet seat. Replace the seat bolts through the S5 mounting plate and the seat hinges. Tighten securely.
9. Connect the bidet hose to the S5. Attach the other end of the braided hose to the S5 inlet port.
10. Turn the water back on. Open the shut-off valve slowly and check all connections for leaks.

Test and Adjust

Turn the S5 pressure dial to test the water stream. Adjust the nozzle position if needed. You're done.

Related Reading

• EcoAqua Pro S5 Review: Ultra-Slim 6mm Bidet Attachment That Needs No Electricity
• Why Switch to a Bidet Attachment? 7 Health & Hygiene Benefits You Didn't Know